Subject:
|
Re: R4 Resistor
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 4 Feb 1999 12:01:31 GMT
|
Original-From:
|
Fred G. Martin <fredm@media.mit#nospam#.edu>
|
Viewed:
|
1048 times
|
| |
|
|
where is this list that says 2.94K? please tell me so i can eradicate
the incorrect value.
to answer, yes, just use it, it affects the IR xmit frequency and
nothing else.
fred
In your message you said:
>
>
> I am almost complete with construction of my first handyboard. I used an in
> accurate list to order my components and have a 2.94K resistor instead of
> 3.83K as per the other list I have and the assembly manual. My question
> is; Is the resistor only used for the IR circuit and if so I can run
> without it, correct? I want to wait until I need something else before I
> order just a couple of resistors. any help is appreciated!
>
> Keith L
>
>
|
|
Message has 1 Reply:
 | | Re: Re: R4 Resistor
|
| "Fred G. Martin" schrieb: (...) i have had the same problem, so i havent installed the ir-circuit yet. the mistake is in "The Handy Board Technical Reference" (July 12, 1998) PDF File ... On page 46 ( i am not sure) is a Part Listing: it says : .... (...) (26 years ago, 4-Feb-99, to lugnet.robotics.handyboard)
|
Message is in Reply To:
| | R4 Resistor
|
| I am almost complete with construction of my first handyboard. I used an in accurate list to order my components and have a 2.94K resistor instead of 3.83K as per the other list I have and the assembly manual. My question is; Is the resistor only (...) (26 years ago, 4-Feb-99, to lugnet.robotics.handyboard)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
