Subject:
|
Motor outputs
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 2 Feb 1999 22:47:09 GMT
|
Original-From:
|
Keith - Lui <luikeith@STOPSPAMMERSegr.msu.edu>
|
Viewed:
|
1067 times
|
| |
|
|
Dear all,
I asked this question before but I might have used the wrong wordings. Here I
try again.
As you all know, the HB 's motor outputs give PVM, however, it gave me problems
when I tried to amplify the power (both current and voltage.)
Is there any way I can change in the software/hardware that the motor outputs
gives constant voltages? Or, slow down the frequency of the pulses?
Thanks!
Keith
|
|
Message has 1 Reply:
 | | Re: Motor outputs
|
| (...) I'm not quite sure if this is what you are looking for, but if you need to run motors that are not compatible with the HB's built-in H-bridge, try one of the following: (1) If you need up to twice the current, try piggybacking more motor (...) (26 years ago, 3-Feb-99, to lugnet.robotics.handyboard)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
