Subject:
|
serial board
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 16 Oct 1998 19:06:19 GMT
|
Original-From:
|
OWENP@MAILspamless.ISLANDNET.COM
|
Viewed:
|
917 times
|
| |
| |
I'm having trouble assembling the serial board. When I do the
test(see snip below) I only get about 5 volts. When I try and run
the downloader, I don't see the green light come on. (tried two
different computers....)
any suggestions? thanks in advance,
Owen
Now temporarily jumper the -12 volt supply (pin 6 of the MAX232)
to pin 10 of the MAX232, which is the input side of this output stage. Again measure the voltage at
pin 3 of J9---it should now read +10 to +12 volts.
|
|
Message has 1 Reply: | | Questions about sensors
|
| Hi all, I'm having fun with my HB! For a software guy like me a 8 bit processor at 2 Mhz with 32K of RAM is a little small but it's so easy to add sensors to it it's just plain fun! But I'm an hardware newbie and I need more info on the sensors I (...) (26 years ago, 20-Oct-98, to lugnet.robotics.handyboard)
|
4 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|