To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 4509
4508  |  4510
Subject: 
Re: Vector2X and motors
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Tue, 13 Oct 1998 20:06:53 GMT
Original-From: 
Tom Brusehaver <(tgb@)antispam(cozy.wamnet.com)>
Reply-To: 
tgb@wamnetSTOPSPAM.com
Viewed: 
4225 times
  
> I just read the compass.asm file. I don't know very much about assembly
> langage, but it seems that some of the motor commands are used in it.
> Can I still use the 4 (or a least 2) motors outputs to drive motors while
> using the compass.
> Are there any limitations induced by the use of this programm?

I wrote the compass routines, and needed at least 2 outputs. The
motors were the most convenient places to get output.

I am just wondering if someone else has fixed the byte swapping
problem?   Every once in a while the results are byte swapped. I
started looking at it last night, and nothing seems to make sense??



Message is in Reply To:
  Vector2X and motors
 
Hy, I just read the compass.asm file. I don't know very much about assembly langage, but it seems that some of the motor commands are used in it. Can I still use the 4 (or a least 2) motors outputs to drive motors while using the compass. Are there (...) (28 years ago, 13-Oct-98, to lugnet.robotics.handyboard)

2 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR