Subject:
|
Vector2X and motors
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 13 Oct 1998 20:47:51 GMT
|
Original-From:
|
Francois Garancher <zcees34@^avoidspam^ucl.ac.uk>
|
Viewed:
|
1090 times
|
| |
|
|
Hy,
I just read the compass.asm file. I don't know very much about assembly
langage, but it seems that some of the motor commands are used in it.
Can I still use the 4 (or a least 2) motors outputs to drive motors while
using the compass.
Are there any limitations induced by the use of this programm?
Thanks
|
|
Message has 1 Reply:
 | | Re: Vector2X and motors
|
| (...) I wrote the compass routines, and needed at least 2 outputs. The motors were the most convenient places to get output. I am just wondering if someone else has fixed the byte swapping problem? Every once in a while the results are byte swapped. (...) (26 years ago, 13-Oct-98, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
