Subject:
|
Re: Download problems
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 26 Jun 1998 20:54:09 GMT
|
Original-From:
|
Fred G. Martin <fredm@media.mitNOMORESPAM.edu>
|
Viewed:
|
3390 times
|
| |
|
|
check that your pcodeb.s19 file is not corrupted (i.e. get a fresh
copy from the web site)
it is possible that you have a RAM failure.
fred
In your message you said:
> Hi there, I am having some strange downloading problems. I have had my
> handyboard working in the past but cannot get ti to work now. I am using
> a macintosh with the lastest version of the mac downloader. The first
> segment of the downloading goes fine and the second stage where it loads
> the pcode to the handyboard almost completes. The downloading gets to
> 7360 bytes instead of something like 7500. An error message comes up and
> says that the bytes programmed does not match the bytes sent and to check
> the power on the board because low power conditions can cause memory
> errors. I have checked through the board quite carefully. The only
> things that I think could be wrong are that the voltage at pin 28 of the
> memory chip is 5.2 volts. Is this a problem?
>
> Any suggestions would be greatly appreciated. Thanks
>
> Robert Gaunt
> University of Victoria
>
>
|
|
Message is in Reply To:
 | | Download problems
|
| Hi there, I am having some strange downloading problems. I have had my handyboard working in the past but cannot get ti to work now. I am using a macintosh with the lastest version of the mac downloader. The first segment of the downloading goes (...) (28 years ago, 26-Jun-98, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
