Subject:
|
Re: Handy Board problem
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 19 May 1998 19:11:46 GMT
|
Original-From:
|
Paul Wiegmans <spectral@simplex.SPAMCAKEnl>
|
Viewed:
|
1415 times
|
| |
|
|
At 21:48 6-5-98 +0200, you wrote:
> I use the Siemens SFH506-36 instead of the Sharp, and it works just fine. I
> know there also is another compenent you can use, but I don't know the name
> of it anymore, sorry. Perhaps if Maarten Emke reads this, he knows what I
> mean.
You probably mean the Sharp GP1U5x. That one is modifiable so that it can
be read like an analog signal.
If anyone can direct me to a company in the Netherlands which sells these
parts, I would very much like to know. Thanks.
> Be carefull by the way, the pin lay-out is different:
>
> Sharp IS1U60
> 1: out
> 2: gnd
> 3: vcc
>
> Siemens SFH506-36
> 1: gnd
> 2: vcc
> 3: out
>
> Thanks to Maarten Emke again for this info.
>
> Hope this helps,
>
> Jeroen van der Vegt,
> A.J.vanderVegt@ITS.TUDelft.nl
*************************************************
* de groetjes van..... Paul Wiegmans *
* spectral@simplex.nl *
* fidonet 2:500/143.1 *
* ICQ #10542882 *
*************************************************
|
|
Message is in Reply To:
 | | Re: Handy Board problem
|
| I use the Siemens SFH506-36 instead of the Sharp, and it works just fine. I know there also is another compenent you can use, but I don't know the name of it anymore, sorry. Perhaps if Maarten Emke reads this, he knows what I mean. Be carefull by (...) (27 years ago, 6-May-98, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
