To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 3809
3808  |  3810
Subject: 
Re: Handy Board problem
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Wed, 6 May 1998 23:11:27 GMT
Original-From: 
Charley Webb <charley@esslink.!ihatespam!com>
Viewed: 
4105 times
  
Okay, thanks for the information...

At 09:48 PM 5/6/98 +0200, Jeroen van der Vegt wrote:
> I use the Siemens SFH506-36 instead of the Sharp, and it works just fine. I
> know there also is another compenent you can use, but I don't know the name
> of it anymore, sorry. Perhaps if Maarten Emke reads this, he knows what I
> mean.
> Be carefull by the way, the pin lay-out is different:
> 
> Sharp IS1U60
> 1: out
> 2: gnd
> 3: vcc
> 
> Siemens SFH506-36
> 1: gnd
> 2: vcc
> 3: out
> 
> Thanks to Maarten Emke again for this info.
> 
> Hope this helps,
> 
> Jeroen van der Vegt,
> A.J.vanderVegt@ITS.TUDelft.nl
> -----Original Message-----
> From: Charley Webb <charley@esslink.com>
> To: handyboard@media.mit.edu <handyboard@media.mit.edu>
> Date: zondag 3 mei 1998 04:57
> Subject: Handy Board problem
> 
> 
> > I was wondering if anyone knows where I could purchase the Sharp Is1U60 IR
> > detector. I have looked for it, however none of the distributors I have
> > checked with even carry it.
> > I tried Digikey, Mouser Electronics, JDR, Jameco, BG Micro, and others.
> > 
> > Any information GREATLY appreciated.
> > 
> > WebGard LLC dba ESSLink
> > World Wide Web: http://www.esslink.com
> > Email: info@esslink.com
> > Phone: (860) 693-2448
> > Toll Free: 1-800-838-2302
> > Fax: (860) 693-6298
> > 
> > 
> 
WebGard LLC dba ESSLink
World Wide Web: http://www.esslink.com
Email: info@esslink.com
Phone: (860) 693-2448
Toll Free: 1-800-838-2302
Fax: (860) 693-6298



Message is in Reply To:
  Re: Handy Board problem
 
I use the Siemens SFH506-36 instead of the Sharp, and it works just fine. I know there also is another compenent you can use, but I don't know the name of it anymore, sorry. Perhaps if Maarten Emke reads this, he knows what I mean. Be carefull by (...) (29 years ago, 6-May-98, to lugnet.robotics.handyboard)

3 Messages in This Thread:


Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR