To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 2933
2932  |  2934
Subject: 
Re: Cost of PCBs in UK
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Tue, 4 Nov 1997 09:09:16 GMT
Original-From: 
Bill Coghill <BILL@ALTAUDIO.spamlessEDNET.CO.UK>
Viewed: 
1640 times
  
I have replied to Colin personally on this, apoligising for flaming him on
the board prices.   Since no one seems to do the kits in the uk (yet), I
was looking to pick one up there.

However the cost of three months away is such I think I'm in no position to
buy anything till middle of next year !

Bill

   If anyone else finds the price of my Handy Board PCBs
excessive please contact me directly rather than placing
this type of comment on the list. I will happily discount
the price, to cost if necessary, to students and anyone else
with a genuine interest in robotics who would like a set of
boards but is unable to afford them. My aim is not to make a
fortune out of my fellow robot enthusiasts. Such concessions
however are not applicable to those about to embark on a
three month holiday on the other side of the globe.
   On the subject of far flung locations, following an
enquiry from Austria (thanks again Bernhard) I find that I
am able to supply mainland Europe for the same price as UK.
That is a set of blank HandyBoard and Charger/IF PCBs for
£19-50 including air mail postage.

Colin Barnard
Miranda Robotics
'O brave new world that has such creatures in it'

54 London Road
Teynham
Kent ME9 9QN
England

Tel: +44 (0)1795 521167


_____________________________________________________________________
Bill Coghill     Mobile +44 (0)410 509 738
Alternative Audio, Edinburgh Phone/Fax +44 (0)131 225 1986
WWW : http://www.Ednet.co.uk/~bill_altaudio/ (I'm working on it !)



Message is in Reply To:
  Expanding HandyBoard
 
Can I use more 74hc374s in conjunction with the Y0 to Y5 lines on the Expansion bus to give me more digital outputs. Could I then just "poke" to change values. Has anyone done this, or is it indeed possible ??? On another note, I'm going to (...) (27 years ago, 3-Nov-97, to lugnet.robotics.handyboard)

3 Messages in This Thread:


Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR