Subject:
|
Cost of PCBs in UK
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 4 Nov 1997 04:35:03 GMT
|
Original-From:
|
Colin Barnard <colin@prospero.u-(nospam)net.com>
|
Viewed:
|
1323 times
|
| |
|
|
Bill Coghill wrote:
> On another note, I'm going to Australia on holiday for 3
> months. Does
> anypone know of Handy Board PCB suppliers in the Sydney
> area, as I be its
> cheaper than getting them in the UK !
If anyone else finds the price of my Handy Board PCBs
excessive please contact me directly rather than placing
this type of comment on the list. I will happily discount
the price, to cost if necessary, to students and anyone else
with a genuine interest in robotics who would like a set of
boards but is unable to afford them. My aim is not to make a
fortune out of my fellow robot enthusiasts. Such concessions
however are not applicable to those about to embark on a
three month holiday on the other side of the globe.
On the subject of far flung locations, following an
enquiry from Austria (thanks again Bernhard) I find that I
am able to supply mainland Europe for the same price as UK.
That is a set of blank HandyBoard and Charger/IF PCBs for
£19-50 including air mail postage.
Colin Barnard
Miranda Robotics
'O brave new world that has such creatures in it'
54 London Road
Teynham
Kent ME9 9QN
England
Tel: +44 (0)1795 521167
|
|
Message is in Reply To:
 | | Expanding HandyBoard
|
| Can I use more 74hc374s in conjunction with the Y0 to Y5 lines on the Expansion bus to give me more digital outputs. Could I then just "poke" to change values. Has anyone done this, or is it indeed possible ??? On another note, I'm going to (...) (27 years ago, 3-Nov-97, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
