Subject:
|
Re: Board synch problem
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Mon, 20 Oct 1997 17:49:11 GMT
|
Original-From:
|
Craig Maynard (EE) <craig.maynard@sait.ab.ca%IHateSpam%>
|
Viewed:
|
3539 times
|
| |
|
|
I've noticed the only limited success I've had downloading pcode_hb.s19 is
- with older slower systems that have _no_ modem cards installed using dlm
- with win95 or win311 systems using hbdl with no modem cards as well.
The hbdl downloads them monitor, then the actual code, but complains that
config=0F every time (and fails)..
If I set the config register in hbdl's dialog box to 0F, then it succeeds
in downloading without complaint, but ( of course ) won't run.
I am anxious to impliment these wonderful boards in a course I am
developing for January, but am "thwarted". Can someone perform a
"thwart-removal"?
Craig
www.starcard.com/~cybug
www.nucleus.com/wcrg
On Mon, 20 Oct 1997, John Duff wrote:
> I'm not sure if my follow up message made it, appears to have bounced. Just in
> case, the problem resolved when I took out the modem and network cards.
> Interestinly, the handyboard battery was nearly discharged when the problem
> surface. The cards had been present from the beginning, and the config had not
> been changed. Thanks
>
> Fred G. Martin wrote:
>
> > last week someone reported solving this by letting the battery charge.
> > let us know if that works.
> >
> > am assuming that nothing changed in your config (cpu, cables, etc).
> >
> > fred
> >
> > In your message you said:
> > > My board has been running well for a few months. Last week it would not
> > > sychronize with IC 3.1. Also, no initial LCD display and heartbeat.
> > > After several attempts I was able to download pcode, but received a
> > > message suggesting the config register needed to be reinitialized. Since
> > > then, the initial LCD display is normal, with a heartbeat, but I can't
> > > sync with the board. Repeated attempts to download p-code and initialize
> > > the config register have failed using IC 3.1, hbdl and dl.
> > > Any thoughts? Thank you.
> > >
> > >
>
>
>
>
|
|
Message has 1 Reply:
 | | Re: Board synch problem
|
| two things you can try: 1. use DLM to download the CONFIG0C.S19 file. Make sure to use the -eeprom flag. This will cause it to burn the config register to the proper value. 2. Have you tried Randy Sargent's DL.EXE for DOS / Win 3.1 full screen DOS (...) (29 years ago, 20-Oct-97, to lugnet.robotics.handyboard)
|
Message is in Reply To:
| | Re: Board synch problem
|
| I'm not sure if my follow up message made it, appears to have bounced. Just in case, the problem resolved when I took out the modem and network cards. Interestinly, the handyboard battery was nearly discharged when the problem surface. The cards had (...) (29 years ago, 20-Oct-97, to lugnet.robotics.handyboard)
|
6 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
