Subject:
|
Re: Connected Radioshack truck
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 6 Feb 1996 20:30:01 GMT
|
Original-From:
|
Tom Cicatelli <cica@tiac.net*saynotospam*>
|
Viewed:
|
2351 times
|
| |
|
|
> like Ram,
> I connected successfully a radio shack RC truck (4WS) to the handy board.
(snip)
> I am still looking for cheap shaft encoders, and good DC motors drawing less
> than 600mA.
I also have one of the Radio Shack RC trucks. A good solution for shaft
encoding would be to glue a couple (or 4) magnets to the inside rim of the
rear tires. Then glue a hall effect sensor to the axle. When the wheel
spins, the hall effect sensor would sense the magnets.
__________________________________________________________________________
Tom Cicatelli cica@tiac.net
Melrose, Massachusetts
__________________________________________________________________________
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
