Subject:
|
PA7
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sat, 30 Mar 1996 00:30:40 GMT
|
Original-From:
|
Dirk W. Edmonds <dedmonds@cs.umn.SPAMCAKEedu>
|
Viewed:
|
2185 times
|
| |
|
|
Another Q or 2 about using the servo capabilities of the handy board.
It has been established that the servo motor output is actually digital
output 9 (J2-9) (position numbered 15 (on the silk screen) of connector J2)
1) Is there a separate connection for power, or can I use the power available
from the other J2-9 pins? (or can I use another motor output (from J4)?)
2) Am I correct in believing PA7 (the control output) is the top pin of J2
position 15? (The schematic shows it that way, but it also shows PA7
connected to J2-3 (position numbered 9 on the silk screen)).
Thanks,
Dirk
|
|
Message has 1 Reply:
 | | Re: PA7
|
| (...) no,this is wrong. The servo output is J2 - 9, not J2 - 15. (...) you need a 5 volt source to power the servo. The Handy Board 5 volt supply can be used, but this will put a lot of stress on the system regulator. It would be better to get a (...) (29 years ago, 30-Mar-96, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
