To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 2350
2349  |  2351
Subject: 
Re: servo modification
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Tue, 17 Jun 1997 23:54:12 GMT
Original-From: 
Chuck McManis <cmcmanis@freegate.net/avoidspam/>
Reply-To: 
cmcmanis@freegate.^spamless^net
Viewed: 
3826 times
  
Phet, you took off the wrong end. Take the _top_ off the servo and
expose the geartrain. Then remove the pot and neuter it as described
in the instructions.

--Chuck

Phethsavong Prachith wrote:
> 
> Hi,
> 
> I'm having some trouble modifying a servo i've purchased from tower
> hobbies.
> The brand i'm using is Tower Hobbies System 3000 STD BB TS-69. I've read
> the instructions on modifying Futaba FP-S148 servo but internal
> mechanisums for the TS-69 seem to but quite
> different. After unscrewing the four screws and removing the back cover
> I immediately saw a PCB and having some trouble prying it off. Has
> anyone modify these brand of standard servos?
> I got them since they were priced at 3 for $47.00 and they have ball
> bearings; a great price i think. If anyone is interested in purchasing
> them the stock number is SM3751.
> 
> thanks for any input,
> phet



Message is in Reply To:
  servo modification
 
Hi, I'm having some trouble modifying a servo i've purchased from tower hobbies. The brand i'm using is Tower Hobbies System 3000 STD BB TS-69. I've read the instructions on modifying Futaba FP-S148 servo but internal mechanisums for the TS-69 seem (...) (29 years ago, 17-Jun-97, to lugnet.robotics.handyboard)

2 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR