Subject:
|
Re: 6500 Sonar and HandyBoard
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 3 Jun 1997 13:01:18 GMT
|
Original-From:
|
Tom Brusehaver <tomb@STOPSPAMMERSnetperceptions.com>
|
Viewed:
|
1355 times
|
| |
|
|
F> Kent,
F> I read your quick explaination of how to connect
F> the Polaroid 6500 sonar board to the HandyBoard, and I have a
F> couple of questions....
F> Mainly, you mention that the INIT
F> signal plugs into pin 9 of the second motor driver chip socket,
F> and that BINH plugs into pin 1. So then am I to assume that you
F> need to remove the motor driver chip, and render the two motor
F> ouputs unusable (leaving 2 usable)? Currently, I'm switching on
F> the Vector2X compass with one of the motor ports, and the other
F> two are driving the motors. So, obviously, something would have
F> to go... Any suggestions?
F> Thanks for your help,
F> Fred Cass
I am not Kent, but the V2X and the sonar both use motor 2 control
lines. It works fine, I have it working on my robot. When I did the
V2X, I chose a pin that was unused by the sonar.
|
|
Message is in Reply To:
 | | 6500 Sonar and HandyBoard
|
| Kent, I read your quick explaination of how to connect the Polaroid 6500 sonar board to the HandyBoard, and I have a couple of questions.... Mainly, you mention that the INIT signal plugs into pin 9 of the second motor driver chip socket, and that (...) (27 years ago, 20-May-97, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
