To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 2098
2097  |  2099
Subject: 
Re: I think I blew my HB :(
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Mon, 5 May 1997 13:47:24 GMT
Original-From: 
Mike Ross <MROSS@OUTLANDspamcake.JSC.NASA.GOV>
Viewed: 
439 times
  
On Fri, 2 May 1997, MAR ERICSON wrote:

Help!

I put 12 V into the power header by accident for about 1 second.
Now when I turn it on, all I get is the BATT, PWR, 1R, 2R, 3R, 4R lit and
the LCD just has the 1st line all lit. I tried to put it in bootstrap and
stuff, but everthing I do the same occurs. When I try to load the .s19
file all I get is "Wrong port or board mode". Can someone tell me what's
wrong. Do I have to replace the entire HB?

I did the something similar, with the same results.  I poked around a
little, but ended up buying a Tcomp (E1 based board from Ray Butts) and
gluing it to the HB as a power supply.  This meant using a new programming
environment, but it only cost about $70 to recover.  My other option was a
new HB.


* Michael L. Ross/C33 | Lockheed Martin Eng & Sci Svcs Co. ****
* Robotics Department | 2400 Nasa Rd. 1, Houston, TX 77058*****
* (281)333-7094; (281)333-6071 fax*    #include <disclaimer.h>*
* Finger me for my public key.  mross@outland.jsc.nasa.gov ****



Message has 1 Reply:
  Re: I think I blew my HB :(
 
So you only recovered the power supply? Everthing else was bolwn up? I tested my motor chips and they appears fine so far as I can tell. I also had external circuitry with some cmos logic (inverters) and they were fine too so I imagine the latches (...) (27 years ago, 5-May-97, to lugnet.robotics.handyboard)

Message is in Reply To:
  I think I blew my HB :(
 
Help! I put 12 V into the power header by accident for about 1 second. Now when I turn it on, all I get is the BATT, PWR, 1R, 2R, 3R, 4R lit and the LCD just has the 1st line all lit. I tried to put it in bootstrap and stuff, but everthing I do the (...) (27 years ago, 2-May-97, to lugnet.robotics.handyboard)

4 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR