Subject:
|
Re: serial connection
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 23 Apr 1997 05:36:56 GMT
|
Original-From:
|
Chuck McManis <cmcmanis@netcom*ihatespam*.com>
|
Reply-To:
|
cmcmanis@netcom.!NoSpam!com
|
Viewed:
|
4023 times
|
| |
|
|
Tunde Gyurics wrote:
>
> Hi,
>
> I am still trying to get the PC-Handyboard connection to work. I got as
> far as downloading the pcode_hb.s19 file successfully. After I turn the
> main board power off and back on (reset), I should get a message on the
> LCD screen ("Interactive-C v 2.81 9/28/93...") but instead the LCD screen
> just stays lit on, without displaying any messages.
Your LCD is bad. Either the logic to it is in error (check for
an open on the E pin) or the LCD itself is non-functional.
If IC cannot talk to the LCD it won't run.
--
--Chuck McManis http://www.professionals.com/~cmcmanis/index.html
All opinions in this message are those of the author. No warranty as to
the suitability or accuracy is stated or implied. Use at your own risk.
cmcmanis@netcom.com +1.408.524.4805
|
|
Message has 2 Replies:
 | | Re: serial connection
|
| (...) and then Chuck McManis wrote: (...) Not necessarily. There could be a problem with the memory circuit that is preventing pcode_hb.s19 from loading properly. Tunde, use a multimeter to check all of the connections in the memory circuit (...) (30 years ago, 23-Apr-97, to lugnet.robotics.handyboard)
|
Message is in Reply To:
| | serial connection
|
| Hi, I am still trying to get the PC-Handyboard connection to work. I got as far as downloading the pcode_hb.s19 file successfully. After I turn the main board power off and back on (reset), I should get a message on the LCD screen ("Interactive-C v (...) (30 years ago, 22-Apr-97, to lugnet.robotics.handyboard)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
