 | | Resets
|
| I traced my reset problem down to the fact that there is a ton of electrical noise in the chip power (+5V). The noise is there only when motors are running. After a minute or so of running the motors, I'll get a runtime error or the board will just (...) (29 years ago, 21-Mar-96, to lugnet.robotics.handyboard)
| | | | | Re: Resets
|
| (...) I can't say that I have an explanation of why the motors would work at first and then cause problems later, but I can say that: Not all motors work with the Handy Board. In particular, motors that want to draw too much current (e.g., more than (...) (29 years ago, 22-Mar-96, to lugnet.robotics.handyboard)
| | | | | Re: Resets
|
| I have a few suggestions, these are all things that I have seen before to help reduce noise from motors I think that the problem might be due to crap getting back to the power line... thereby causing the DS1233 to say, time to reset... - try a (...) (29 years ago, 23-Mar-96, to lugnet.robotics.handyboard)
| | | | | Re: Resets
|
| If I add a separate motor power to the L293's, can I keep the ground lines common? If not, what pins are motor ground? (I know pins 4,5,12, and 13 are ground) Thanks. -John (...) (29 years ago, 23-Mar-96, to lugnet.robotics.handyboard)
| |
