 | | Resets —John S Seng
|
| | | Hi. My board was working fine until I hooked up some different motors to it today. It seems that whenever I try to drive the motors the low battery light lights up and the board gets reset. I checked the battery and it reads 8.4V before and while (...) (29 years ago, 18-Mar-96, to lugnet.robotics.handyboard)
|
| | | |
| | | | | Re: Resets —Fred G. Martin
|
| | | | Is it possible that your battery is simply discharged? Does the board exhibit the problem when you try driving the previous motors that did not give you a problem? Regarding the charge light on the serial board, are you sure that the charge rate (...) (29 years ago, 18-Mar-96, to lugnet.robotics.handyboard)
|
| | | | |
| | | | | | Re: Resets —John S Seng
|
| | | | Actually, when I first tried the new motors, I was able to use them for a while. It wasn't until I went to download a different program that it started happening. That's what's confusing me. Is it possible that the L293D is burned or something like (...) (29 years ago, 18-Mar-96, to lugnet.robotics.handyboard)
|
| | | | |
| | | | | | Re: Resets —Fred G. Martin
|
| | | | (...) Well that would do it---it would discharge your battery. You actually should be getting more like 9.6 to 10v from a fully charged battery. Why don't you get an adatper that works and charge your battery until it's slightly warm and then see if (...) (29 years ago, 18-Mar-96, to lugnet.robotics.handyboard)
|
| | | | |
