| | Re: Motors & handyboard Chuck McManis
|
| | (...) It has been my experience that it is easier to change the drive circuitry than it is to change the motors. The circuitry is just solder and chips, the motors are mechanical tooling. Driving the Tamiya BullDozer from the HB is certainly (...) (28 years ago, 18-Feb-97, to lugnet.robotics.handyboard)
|
| | |
| | | | Re: Motors & handyboard rabbit
|
| | | | (...) Why not use the H-bridge that is already on the bulldozer? If you work backwards throught the motor driver circuitry, or use the RF controller to send commands to the dozer and see what voltages change you can figure out where the inputs to (...) (28 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
|
| | | | |
| | | | | | Re: Motors & handyboard Chuck McManis
|
| | | | (...) This is also excellent advice. On one R/C car I had, I ended up having to simulate the signal input to the controller because the h-bridge was so screwy but it does save you from having to build your own. On a related note, Radio Shack sells (...) (28 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
|
| | | | |