Subject:
|
Handyboard assembly
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 7 Mar 1996 16:51:39 GMT
|
Original-From:
|
Ramasubramanian, M. K. <(rammk@eos.ncsu.edu)SayNoToSpam()>
|
Viewed:
|
2074 times
|
| |
|
|
We have assembled our fifth handyboard and have run into the following
problem. (The other four boards went smoothly). The command dl pcode_hb.s19
downloads fine just as it did on the four other boards that we have built.
However, when I power cycle the board, I do not get the familiar Interactive
C and the heart beat monitor. The LCD panel is dim, just as it was in the
bootstrap mode and the power light (green) is on.
The board checks out OK, the oscillator is working fine.
When I hookup other handyboards, everyting goes smoothly with the same
charger and wires that I have setup.
Does anyone have suggestions how I might proceed further in troubleshooting
this problem?
Thanks for your time.
Ram
-----------------------------------------------------------------Dr. M. K.
Ramasubramanian
Assistant Professor
Department of Mechanical & Aerospace Engineering
North Carolina State University
Box 7910
Raleigh, NC 27695-7910
(919)515-5268
(919)515-7968 (Fax)
rammk@eos.ncsu.edu
|
|
Message has 1 Reply:
 | | Re: Handyboard assembly
|
| Ah, the classic "I built it and it doesn't work" story. Did you follow the incremental building instructions? I take it the answer is no. My suggestion is to pull all of the chips, and run through the series of incremental tests in the building (...) (29 years ago, 7-Mar-96, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
