 | | DS1233-10
|
|
Hello everybody, HELP HELP HELP ... I can't found the Dallas 1233-10 circuit in Belgium, it's the only part I need to continue my HB to the end. BUT I found an IC from Maxim that could do the job, is it true? This part is the MAX809L (threshold of (...) (28 years ago, 8-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | Re: "Mobile Robots: Inspiration to Implementation" for FIVE BUCKS!!
|
|
(...) I like the book "Sensors for Mobile Robots" by H.R. Everett. It doesn't have alot of microrobtics in it but is good for theory and to build you a foundation in Robotics Technology. (28 years ago, 8-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Mini Board or Handy Board?
|
|
(...) In answer to your last question, the best price I have seen for the MC68HC11E1FN is at B.G. Micro for $6.95 if my memory is correct. I have dealt with them before and not had any problems so far. You can check the price on their web page at (...) (28 years ago, 7-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | error message
|
|
Hello everybody, Whenever i load any program to the handyboard the following message is displayed " IC is now dangerously running low on memory. Yous should makesure that your PC has atleast 550-600K of lower memory free before staring" iam using a (...) (28 years ago, 7-Nov-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Mini Board or Handy Board?
|
|
(...) A little background, my first robot controller was the 1802 based ELF processor ca. 1979, it didn't do much. The first mobile robot I built was tethered to a Heathkit H-8. The first untethered robot used a Xerox 820 mainboard, and a lot of (...) (28 years ago, 7-Nov-96, to lugnet.robotics.handyboard)
|
