 | | Phasing Errors and as11
|
| Has anyone managed to sort out all the "phasing errors" you get when you try to reassemble pcode v3.1 using as11? Thanks, George Musser georgejr@musser.com (25 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
| | | | | How many 5 wire steppers?
|
| I have a Handyboard with the expansion board. I'm building an interactive sculpture with the board. This is my first use of my Handyboard. I would like to hook up five or six stepper motors to the board. The motors I'm using are scrapped from old (...) (25 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
| | | | | Re: Beginners Quest.
|
| The E1 chip works with the Handy Board. Actually, any of the 52-pin PLCC 6811s will work. You may have to change the CONFIG register to get Interactive C to run. Fred (...) (25 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
| | | | | Pyro sensor
|
| Hi! Does anyone has implemented a person following behavior? If so I would appreciate any hardware or software details. If I'm not wrong, I can modify one of those PIR detectors used with burglar alarms as it has the sensing element and amplifiers (...) (25 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
| | | | | Re: Beginners Quest.
|
| Well, I almost sure that you have to use the A1, the other chips have a different configuration, like they can have an eeprom. (25 years ago, 13-Jun-01, to lugnet.robotics.handyboard)
|
|
