 | | Basic Stamp to Handy Board Interfacing
|
|
Hello, Has anyone ever interfaced the Stamp to the Handy Board. I am thinking about using the SPI port on the HB to do this. I truly appreciate any assistance. Guillermo (23 years ago, 11-Mar-01, to lugnet.robotics.handyboard)
|
| |
| | Handyboard execution/operation speed
|
|
Hey all: How fast does the HandyBoard with the standard interactive C libraries execute standard IC instructions? What about the software system interrupt at 1kHz and the multitasking overhead, how do they play into things? I know float instructions (...) (23 years ago, 10-Mar-01, to lugnet.robotics.handyboard)
|
| |
| | Request: I2C Bus Handy Board interface Info.
|
|
In 1999 someone requested information on how to interface I2C and the Handyboard. I would like to revisit that request. Any information on components and code to use would be appreciated. Andrew P. Loy andyl@citlink.net aloy1@utk.edu (23 years ago, 9-Mar-01, to lugnet.robotics.handyboard)
|
| |
| | Re: Drill Motor
|
|
Yes, it can be used to control a drill motor, but probably not directly. It can drive 9V motors at 1 AMP (i think, depending on which h-bridge chips you have). I'm sure a drill motor will draw more than 1 amp, so you will need to use external power (...) (23 years ago, 7-Mar-01, to lugnet.robotics.handyboard)
|
| |
| | Drill Motor
|
|
Hi, All. I'm new to the list, but I was wondering if the handy board could be used to control something like a 7.2V cordless drill that you could get from Home depot? (23 years ago, 7-Mar-01, to lugnet.robotics.handyboard)
|
