| | Re: Short Circute Problem -- EMERGENCY
|
|
Hi Rainer, thanks for your advise on this. i will fallow the test cycles mentioned in HB manual. What i noticed is , charging circuit(changeing/interface board) working and HB is working in bootstrap mode also. it is able to sync with IC in (...) (24 years ago, 1-Feb-01, to lugnet.robotics.handyboard)
|
|
| | Re: hacking servo motors
|
|
Thanks guys(Rainer and Gary) for your valuble ideas. i think i will go with the Rainer's method because of the simpicity(only one motor). any way i designed my sensor module for beacon finding long back with three sensors. so now i got confidence (...) (24 years ago, 1-Feb-01, to lugnet.robotics.handyboard)
|
|
| | Re: Short Circute Problem -- EMERGENCY
|
|
(...) Hi Raj, first you should have a look at the assembly manual (URL) are testing description for every step of assembling. So you'll possibly find the proplem on your own. If not you will have to describe the spot you touched your HB more precise (...) (24 years ago, 1-Feb-01, to lugnet.robotics.handyboard)
|
|
| | Short Circute Problem -- EMERGENCY
|
|
Hi Guys, I got a serious problem with my HB. Bymistake my 12 volts 1 amp power cord touched to HB(which is on at that time) circut track near the HB's direct charge connector. then there is short circuit crisp sound from that are and HB stoped (...) (24 years ago, 1-Feb-01, to lugnet.robotics.handyboard)
|
|
| | Re: Looking for GP2D02 sensor connector
|
|
(...) (URL) (...) (24 years ago, 31-Jan-01, to lugnet.robotics.handyboard)
|
|
| | Re: Looking for GP2D02 sensor connector
|
|
Try this: (URL) luck, Gary Livick (...) (24 years ago, 31-Jan-01, to lugnet.robotics.handyboard)
|
|
| | Looking for GP2D02 sensor connector
|
|
Hi, I have bought recently a bunch of Sharp IR-distance sensors model GPD202. I'm going to use them for our laboratory courses, but I can't find the 4-pin connector this sensor uses. I would be please in anybody could tell me the reference of this (...) (24 years ago, 31-Jan-01, to lugnet.robotics.handyboard)
|
|
| | Typo in subject heading Meant "Sharp sensor WITHOUT Expansion Brd."
|
|
(...) (24 years ago, 31-Jan-01, to lugnet.robotics.handyboard)
|
|
| | Sharp GP2D02 sensor with Expansion Board.
|
|
Hi all, I am trying to use the Sharp GP2D02 sensor with the handy board. I dont have the expansion, thus no real digital outputs. I do know that digital output 9 can be reconfigured to act as a digital output. I have tried modifying some of the (...) (24 years ago, 30-Jan-01, to lugnet.robotics.handyboard)
|
|
| | Re: IR control
|
|
Well, I did find this link over the weekend and downloaded Max Davies excellent routines for the IR reciever. However, despite over 10 hours of attempts, I was unable to get my preferred remote (a Toshiba) configured correctly. It was very strange (...) (24 years ago, 29-Jan-01, to lugnet.robotics.handyboard)
|