 | | Re: Miniboard download random failures
|
|
(...) Are you running DLM from a dos window in Win9x? I've had this problem but it usually stops when I run it in DOS. Just a thought. -Jim Munro <jimmn@xnet.com> (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
|
| |
| | Freeware ICC11 and bad iasm11.exe?
|
|
Me again, I just got the ICC11 freeware from the Miniboard site and installed it, moving the crt.s over as it says to do in the docs, etc. I tried to compile the test compile of icc11 dhry.c printf.c and got a LOT of "phasing" errors, whatever that (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
|
| |
| | Miniboard download random failures
|
|
Hello, I just finished building a Miniboard using the HC811E2 processor. After swapping the Rx and Tx lines on my serial cable the download and reset switch do as the manual says. However, when I use dlm to download a program the bootstrap section (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
|
| |
| | serial communication
|
|
Hi.. I am also facing problem in serial communications. My problem is that I am trying to use the handyboard to drive a modem. I have used a cross-serial cable to connect my handyboard's external serial board to a modem. But whenever I run my app, (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
|
| |
| | R: communication via serial port
|
|
Using java and comm API ? ----- Original Message ----- From: Ray Tang <raytang_1@hotmail.com> To: <handyboard@media.mit.edu> Sent: Thursday, October 05, 2000 4:49 AM Subject: communication via serial port (...) and (...) the (...) a (...) (26 years ago, 5-Oct-00, to lugnet.robotics.handyboard)
|
