 | | hbdl question
|
|
when using hbdl what does the burn the board option do? It says download to eprom. What file should you download to the eprom? Is this necessary? Thanks, Todd (24 years ago, 27-May-00, to lugnet.robotics.handyboard)
|
| |
| | IC question
|
|
Just got my handyboard, and I am new to programming, so I have a probably simple question for you all. I have been playing around with IC trying to get responses on the LCD from start button presses. if I send the following on the IC command line : (...) (24 years ago, 27-May-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Digital outputs.
|
|
You can use solid state relays with 5 VDC inputs and DC outputs to control large loads. The inputs require very little current. It is less expensive to build transistor switches, which will do the same thing, but obviously much simpler to use (...) (24 years ago, 25-May-00, to lugnet.robotics.handyboard)
|
| |
| | handy board, motor problems
|
|
I have six handy board for academics activities in my University. In two, I have problems: When move power switch ON, the same indicators(leds) of motors outputs work, with load programs and without load programs. ¿What's happening? Thank (24 years ago, 25-May-00, to lugnet.robotics.handyboard)
|
| |
| | CCD on the handyboard ??
|
|
Maybe someone already discussed this argument.... I'd like to connect a CCD to the handyboard, but how ?? What comes out from a CCD ? How to interface the CCD's output signal ? Anyone can help me ? Stefano (24 years ago, 25-May-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Digital outputs.
|
|
Todd, The outputs can control a transistor, that is powered by a separate higher current o/p. (Poor text diagram following) Vsupply _ | / Dig Out ---...---| <- Tansistor \ | |__ Vout (...) Charles Hacker Lecturer in Electronics, Computing and (...) (24 years ago, 25-May-00, to lugnet.robotics.handyboard)
|
| |
| | Digital outputs.
|
|
How would I go about making the digital outputs capable of controlling a higher current than the 5 ma that is standard? Can a switching transistor be controlled by them? Or do I need some sort of IC to do the job? Particularly I would like to be (...) (24 years ago, 25-May-00, to lugnet.robotics.handyboard)
|
| |
| | servos again
|
|
I'm still at my servo question :) the 3 servo routines so far use "normal" digital outputs. There are, according to the FAQ, 4 extra outputs I could use (SPI J6). Does this mean that I could write my own routines to drive 4 extra servos using these (...) (24 years ago, 23-May-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Sharp analog distance sensor
|
|
unsubscribe please. (24 years ago, 23-May-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Sharp analog distance sensor
|
|
(...) I created a website at: (URL) will have to add some new experiences. 1. You definetely should use the device vertical (my choice: Emitter at bottom). I have no clue, how anybody got reliable results when mounting it horizontal. There is no (...) (24 years ago, 22-May-00, to lugnet.robotics.handyboard)
|
