 | | Re: RCX vs. HandyBoard
|
| (...) Here's one I can answer, at least a little bit: There's an HC11 port to gcc-2.8.1 and a Handyboard library to go with it. There's also a GCC-2.9.5 version out there. (URL) get you to either one. I program my Handyboard using Linux and GCC (...) (26 years ago, 25-Apr-00, to lugnet.robotics.handyboard)
| | | | | Re: RCX vs. HandyBoard
|
| (...) Here's one I can answer, at least a little bit: There's an HC11 port to gcc-2.8.1 and a Handyboard library to go with it. There's also a GCC-2.9.5 version out there. (URL) get you to either one. I program my Handyboard using Linux and GCC (...) (26 years ago, 24-Apr-00, to lugnet.robotics.handyboard)
| | | | | driving servos by the handy board!
|
| Dear Sir, I am a new user of the handyboard. In a robot project of building a manipulator, I have to drive for at least 3 servo motors. I have found the routines for driving two servo motors at the same time from the handyboard info website. But, if (...) (26 years ago, 23-Apr-00, to lugnet.robotics.handyboard)
| | | | | Re: RCX vs. HandyBoard
|
| Here are some more specific questions that I still have: 1) Can two handyboards communicate with each other from a distance?, either in the same room (i.e. infrared) or via the internet? 2) Besides Interactive C, what exactly are the other ways that (...) (26 years ago, 23-Apr-00, to lugnet.robotics.handyboard, lugnet.robotics.rcx)
| | | | | Servo function (new?)
|
| Hello all, here's a servo function that I worked up. It's really very simple, but I figured that someone else might want to use/hack it up. My problem was that I wanted to be able to set the servo (non-continuous) at *any* point in its travel (...) (26 years ago, 23-Apr-00, to lugnet.robotics.handyboard)
|
|
