Subject:
|
driving servos by the handy board!
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 23 Apr 2000 23:58:55 GMT
|
Viewed:
|
1129 times
|
| |
|
|
Dear Sir,
I am a new user of the handyboard. In a robot project of building a
manipulator, I have to drive for at least 3 servo motors. I have found the
routines for driving two servo motors at the same time from the handyboard info
website. But, if I need to drive for 3 motors at the same time. Can the
handyboard (without the expansion board) do this?
Also, according to the servo routines, it says that it generates output
signals on Port A bit 7 and Port A bit 5. I don't know which pins on the
digital input pins are corresponding to these two?
Thank you for your reply!
Raymond Law
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
