 | | Re: Charge polarity on each board opposite?
|
|
(...) see the FAQ for an answer to this. (...) did you put the downloader in EEPROM mode before downloading config0c? -Fred (28 years ago, 30-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | RE: Charge polarity on each board opposite?
|
|
On a related note, given the power draw of the HB (minimal) would it be practical on some future design to put a small bridge rectifier. This will cost you ~ 1.4 volts (given two diode drops if I calculate it correctly) but has the advantage that (...) (28 years ago, 29-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Charge polarity on each board opposite?
|
|
(...) Do those two boards (Hboard and I/F) have differing requirements of the transformer charge plugs, as the schematics indicate? I have so many wall-warts around, DC and AC, but they all have the return line on the outside. Perhaps it doesn't (...) (28 years ago, 29-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Photoreflectors
|
|
On Wed, 28 Aug 1996, Werner Kuehnert wrote: Hi ! (...) I have been looking at the overhead projector lamps. After my holidays I was planning on test a few for my projects. ---...--- Ed Spike, E&CE Department, University of Waterloo. E2-3357 * (...) (28 years ago, 28-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | Finally servo works
|
|
I finally made the servo work with my HB .. I'm ashamed to admit that the error was on the software (I didn't activate the servo output with servo_on() ) *8-/ By the way .. is there any other digital input that can be reconfigured to act as an (...) (28 years ago, 28-Aug-96, to lugnet.robotics.handyboard)
|
