|
|
 | | dead hb - alive again
|
| hello. seems my dead handyboard problem of yesterday was a result of a bad adapter, not the board itself. a relief. thanks, claudia (24 years ago, 23-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: Handyboard in mix with SSC II Servo Controller
|
| Hi, There are several steps you should follow. 1..Download the 9600 serial driver form (URL) you that if you use SSC controllers, download the inverted version. 2...Refer to you SSC manual, connect the serial in pin to PA7 of handyboard, PA7 is the (...) (24 years ago, 23-Mar-00, to lugnet.robotics.handyboard)
| | | | | dead hb - overpowered?
|
| hello. i used the wrong dc adapter (15v) to power my hb today. i made the switch to the proper adapter (12v) fairly quickly, and things seemed fine - i was able to download the pcode. but when i rebooted the board, the power died and i've not been (...) (24 years ago, 23-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: resistor pull-up help!
|
| basically, yes. the inputs from the expansion board feed into the inputs on the main board. if you need a high impedance input, your best bet is to cut a trace on the main board and use one of those inputs. the exp bd takes over main board inputs 0 (...) (24 years ago, 23-Mar-00, to lugnet.robotics.handyboard)
| | | | | RE: resistor pull-up help!
|
| Hi, Are the general-purpose analog inputs in the exp board also connected to the pull-up in the HB main? To use that kind of sensors the only way is to cut the trace in the HB, no matter I have or no the ExpBoard? Thanks Jose Luis --- Original (...) (24 years ago, 23-Mar-00, to lugnet.robotics.handyboard)
|
|
