|
|
 | | Re: Vector 2X driver
|
| I just bought a Vector 2X electronic compass for a project. In looking at it the manual, I see that if the 2X is run in slave mode I can clock out data from it at my leisure using any digital pins available on the Handy Board. This could almost be (...) (25 years ago, 15-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: Overcharged battery?
|
| no i disagree with this answer. the HB is designed to be left on normal charge indefinitely. the batts can get a little warm. if they are hot then something is wrong, but a little warm is nothing to worry about. when fully charged and with no load (...) (25 years ago, 15-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: Non-polaroid Sonar
|
| In the sonar code from the web site, the rising edge detection on timer input channel 3 (TIC3) is set like this: bit_clear( 0x1021, 2 ); bit_set( 0x1021, 1 ); According to the little pink book, address 0x1021 is the Timer Control Register 2 (TCTL2) (...) (25 years ago, 15-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: Overcharged battery?
|
| (...) Ouch. You don't want to do that too much or you will torch (may have torched) your NiCds. NiCds do NOT like to be overcharged, it causes a problem called Voltage depression that many mistakenly call "memory effect". [snip] (...) Servos will (...) (25 years ago, 15-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: Overcharged battery?
|
| actually this is to be expected. with no load, the diodes produce no drop. if you're worried, try hooking a DC motor (or other real load -- light bulb, 10 ohm resistor, etc). across the servo motor supply and then measure the voltage. you should see (...) (25 years ago, 15-Mar-00, to lugnet.robotics.handyboard)
|
|
