|
|
 | | RE: HB's mA consume?
|
| Thanks your answer Will, well, seems not easy to give a good use to a solar panel in the HB If I want to connect the a panel to the HB charging circuit, it must be 12V/500mA like the AC adaptor? or with less current (maybe 200 mA) , it can still use (...) (25 years ago, 1-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: HB's mA consume?
|
| If your calculations are correct, and your solar panel provides 40 mA, and you get maybe 6 hours of strong, useful sunlight per day, then I figure you'd need eight solar panels and three battery packs, minimum, to keep the HB running all the time, (...) (25 years ago, 29-Feb-00, to lugnet.robotics.handyboard)
| | | | | HB's mA consume?
|
| Hi, Today I have tested the time the HB can stay powered with his battery (just the board, without any other device attached), its work during aprox. 8 hs, so because the batteries I use are 600 mA, I believe that the consume of the board is around (...) (25 years ago, 29-Feb-00, to lugnet.robotics.handyboard)
| | | | | Re: HB memory capacity
|
| As IC loads each file, it reports how many bytes each one occupies. Just add 'em up. The IC interpreter is said to occupy approximately half of the 32 kB available, so if your code gets up to about 16 kB total, then you need to worry about trying to (...) (25 years ago, 29-Feb-00, to lugnet.robotics.handyboard)
| | | | | Re: Exp. board Servo
|
| (...) Well, since it seems these values often vary from servo to servo I usually set them by using the knob function and scaling it down so I can visually see the numbers I'm putting into it and the result on the servo; turning it until it chatters (...) (25 years ago, 29-Feb-00, to lugnet.robotics.handyboard)
|
|
