| | Re: Just some questions...
|
|
Hi, Eric Davis <Eric_Davis@mindspring.com> wrote in message news:8EE380D7Cericda....63.236... (...) a (...) The recommended battery pack I ordered from DigiKey is rated 9.6V at 500mA. So, Don't over kill the board. And I think the motor chip L293D (...) (25 years ago, 23-Feb-00, to lugnet.robotics.handyboard)
|
|
| | Re: Strange problem of expansion board and handyboard
|
|
It may be because you use the wrong lib_hb.c. There is one that works with the expansion board (one without digital(), analog() and raw_analog() defined, but the expsenc.c will define them so that the I/O port on the expansion board will work). It (...) (25 years ago, 23-Feb-00, to lugnet.robotics.handyboard)
|
|
| | GP2D02
|
|
I can't seem to get any reading off of my GP2D02 sensor? I'm just wondering if I screwed up in connecting to the HB. If someone could tell me where they should be connected on the board that would be great! (25 years ago, 23-Feb-00, to lugnet.robotics.handyboard)
|
|
| | Re: Strange problem of expansion board and handyboard
|
|
it's all a software config issue, there's nothing wrong with your hardware. two questions: 1. what is the root library file that loads when IC starts up, and 2. what files are listed there? f. In your message you said: (...) d (...) s (...) I (...) (...) (25 years ago, 23-Feb-00, to lugnet.robotics.handyboard)
|
|
| | Just some questions...
|
|
Hey all.. I got my handyboard a few days ago.. and I have some questions.. 1) What is a good battery to use? I don't have 8 nicad batteries.. I use a R/C car 9.6V battery pack.. is there some specific need for certian mAh values? 2)What method did (...) (25 years ago, 23-Feb-00, to lugnet.robotics.handyboard)
|