| |
Hey all..
I got my handyboard a few days ago.. and I have some questions..
1) What is a good battery to use? I don't have 8 nicad batteries.. I use a
R/C car 9.6V battery pack.. is there some specific need for certian mAh
values?
2)What method did you use to attach it to the board (I have the
RobotstoreHK one) I ended up using two 18 gauge wires with bannana plugs
at the end.. and the corresponding plugs on the batterypack
3)Anybody have examples of the IC code I can see? i can use the one line
inputs to check, say, the status of a digital input (bump sensor) but when
i write a simple program to sound the buzzer if it hits.. it doesn't work..
Examples would be great!
4) Any good sources on building remote control interfaces? I would like to
have a home built transmitter with a few joysticks and buttons.. any
sources?
Thanks all
-Eric
|
|
Message has 1 Reply:
 | | Re: Just some questions...
|
| Hi, Eric Davis <Eric_Davis@mindspring.com> wrote in message news:8EE380D7Cericda....63.236... (...) a (...) The recommended battery pack I ordered from DigiKey is rated 9.6V at 500mA. So, Don't over kill the board. And I think the motor chip L293D (...) (25 years ago, 23-Feb-00, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
