To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 7478
7477  |  7479
Subject: 
Re: Just some questions...
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Wed, 23 Feb 2000 23:32:56 GMT
Viewed: 
4578 times
  
Hi,


Eric Davis <Eric_Davis@mindspring.com> wrote in message
news:8EE380D7Cericdavismindspringc@209.68.63.236...
> Hey all..
> 
> I got my handyboard a few days ago.. and I have some questions..
> 
> 1) What is a good battery to use?  I don't have 8 nicad batteries.. I use • a
> R/C car 9.6V battery pack..  is there some specific need for certian mAh
> values?

The recommended battery pack I ordered from DigiKey is rated 9.6V at 500mA.
So, Don't over kill the board.  And I think the motor chip L293D can go up
to 700mA (the TI SN754410NE can go up to 1A)  (I think I am right)...  So,
watch out...

You can order the battery cover at DigiKey also.  It is made by SERPAC.
Model 031 or 131 will work fine.

> 
> 2)What method did you use to attach it to the board (I have the
> RobotstoreHK one)  I ended up using two 18 gauge wires with bannana plugs
> at the end.. and the corresponding plugs on the batterypack

I used 22 gauge wires for the connection from battery pack to the board. . .

> 
> 3)Anybody have examples of the IC code I can see?  i can use the one line
> inputs to check, say, the status of a digital input (bump sensor) but when
> i write a simple program to sound the buzzer if it hits.. it doesn't • work..
> 
> Examples would be great!

I got mine to work using those sample code...
Sorry, busy.....  later.... (Someone else please help...)

> 
> 4) Any good sources on building remote control interfaces?  I would like • to
> have a home built transmitter with a few joysticks and buttons.. any
> sources?

Not yet.  I am working on that...  Are you talking about RF or IR??

> 
> Thanks all
> 
> -Eric

--

                                                            Ray



Message has 1 Reply:
  Re: Just some questions...
 
Well, the battery pack I am using is rated for 1450 mAh.. so far.. I have not seen any probems... I was speaking of rf control earlier.. Thanks.. -me (27 years ago, 24-Feb-00, to lugnet.robotics.handyboard)

Message is in Reply To:
  Just some questions...
 
Hey all.. I got my handyboard a few days ago.. and I have some questions.. 1) What is a good battery to use? I don't have 8 nicad batteries.. I use a R/C car 9.6V battery pack.. is there some specific need for certian mAh values? 2)What method did (...) (27 years ago, 23-Feb-00, to lugnet.robotics.handyboard)

3 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR