 | | Re: Excessive clutziness when replacing the NiCad battery
|
|
Hello, everyone: Many thanks to Chuck McManis and Nick Taylor for posting the simple and elegant solution to my problem: install an inline plug Gee, I wish that I had thought of that!. Thanks for the help. Bill Bynum (27 years ago, 8-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | H-bridge chips
|
|
1. Two quick question, when i type 'ps' at the C prompt, i always get the following: PID STAT PC SP ORG Tricks Executing 1 20 c200 fe01 fe00 10 <command line interaction> is that there becoz Interactive C is running or is that something else? 2. my (...) (27 years ago, 8-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Excessive clutziness when replacing the NiCad battery pack
|
|
Hello Bill ... Here is what I've done on both of my HandyBoards and it's given good results. Cut the leads between the board and the battery pack and add 2-pin polarized connectors. Good luck and have fun, - Nick - (...) (27 years ago, 7-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | Excessive clutziness when replacing the NiCad battery pack
|
|
Hello, everyone: I'm having problems when I replace the HandyBoard's NiCad battery. I have probably replaced around 10 battery packs by now on different HandyBoards. On 4 or 5 of the replacements, I end up having to replace the 74HC373 latch, (...) (27 years ago, 7-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | synchronization error
|
|
I'm encountering a synchronization error when calling serial_putchar within a for loop. Here's my code: void test(){ int looper; for (looper=0;looper<16;looper++){ if (looper<7){ serial_putchar(analog(looper)); printf("\nPort: %d Value: (...) (27 years ago, 7-Dec-99, to lugnet.robotics.handyboard)
|
