 | | Re: motor driver circuit -- help needed
|
| Hi, my name is nicolas and I'm a french student in an engineering school at LYON. I make a PCB with the L298N for the handy board. You must remove the L293D that you use for the motor 0 and 1. You put a connector in the socket 16 pin and this (...) (27 years ago, 25-Nov-99, to lugnet.robotics.handyboard)
| | | | | motor driver circuit -- help needed
|
| Hi , I am trying to drive two DC motors of 12v, 2A rating for my robot base. I am looking for the ready-made motor drivers for this. Please sujust me if you guys have any products known. i found one in the web , help me in deciding whether this is (...) (27 years ago, 25-Nov-99, to lugnet.robotics.handyboard)
| | | | | Re: HandyBoard not responding
|
| Hi, Finally I found out what happened. One of the pins of the RJ-11 socket on the handyboard was disconnected from the PCB. So I soldered it back and the handyboard is working fine. Thanks for all your help. Kalyan (...) (27 years ago, 25-Nov-99, to lugnet.robotics.handyboard)
| | | | | Re: HandyBoard Charging
|
| Danny, Glad you've got it working! Gleason Research is a good company to do business with, isn't it? Good luck and have fun with your HB, - Nick - (...) (27 years ago, 25-Nov-99, to lugnet.robotics.handyboard)
| | | | | Re: robot project
|
| (...) Michael: You will not get your program to outrun light. The rf signal is moving at 300,000,000 m/s. If you divide the space between your antennas by 300,000,000 you will get the time difference for the rf arrival time. I believe you will find (...) (27 years ago, 25-Nov-99, to lugnet.robotics.handyboard)
|
|
