Subject:
|
Re: motor driver circuit -- help needed
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 25 Nov 1999 20:07:33 GMT
|
Original-From:
|
bocquet777@aolANTISPAM.com
|
Viewed:
|
1088 times
|
| |
|
|
Hi,
my name is nicolas and I'm a french student in an engineering school at LYON.
I make a PCB with the L298N for the handy board. You must remove the L293D
that you use for the motor 0 and 1. You put a connector in the socket 16 pin
and this connector help the data going into the L298N. The PCB I build is
6cm*10cm but I think I can do a smaller one maybe.
I can send you the PCB if you want or explain you how you can use the L298N
with your handyboard.
If you need more current (4 A contiguous instead of 2 A) you can use one
L298N for controlling just one motor. You put the 2 H-Bridges in parrallel.
kinds regards,
Nicolas.
ECAM at LYON (<A HREF="http://www.ecam.fr">http://www.ecam.fr</A>)
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
