|
| | 64K UPGRADE
|
| When upgrading to 64K, could that be done when still using Interactive C? By the way, what's the main difference between 2.8 and 3.X versions? Advantanges and Disavantages!!! Thanks, Paul (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
| | | | Eltec 442 Pyroelectric Sensor
|
| Hi, I purchased an Eltec 442-3 Pyroelectric Sensor from acroname. I know pin 1 is V+ 5V but I don't know how I should connect pin 2,3,4 to my handy bord/expansion board. I want to use the sensor for detecting people and/or candles. How do I connect (...) (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
| | | | Re: fried memory
|
| it might not be permanently dead, but if it's not, it's not working. one (or more) of the outputs of these two chips is probably shorted to ground or shorted to +5v. the chips get hot when they try to drive this output to a state other than the one (...) (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
| | | | fried memory
|
| I suspect that I fried my memory chip. The handyboard downloads Pcode perfectly, but when it tries to synchronize with interactive C, I get an error. While the board is off the 62256-12LP and the 74HC132 chips stay hot. is there a good diagnostic (...) (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
| | | | Expansion Board and Smooth PWM
|
| I really need to know how to get all my files correct to run both the expansion board and the smooth PWM routines at the same time. I downloaded both zip files but am unsure which files to use. Did I miss something on the web page where it says how (...) (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
| |