| | 64K UPGRADE
|
|
When upgrading to 64K, could that be done when still using Interactive C? By the way, what's the main difference between 2.8 and 3.X versions? Advantanges and Disavantages!!! Thanks, Paul (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
|
|
| | Eltec 442 Pyroelectric Sensor
|
|
Hi, I purchased an Eltec 442-3 Pyroelectric Sensor from acroname. I know pin 1 is V+ 5V but I don't know how I should connect pin 2,3,4 to my handy bord/expansion board. I want to use the sensor for detecting people and/or candles. How do I connect (...) (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
|
|
| | Re: fried memory
|
|
it might not be permanently dead, but if it's not, it's not working. one (or more) of the outputs of these two chips is probably shorted to ground or shorted to +5v. the chips get hot when they try to drive this output to a state other than the one (...) (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
|
|
| | fried memory
|
|
I suspect that I fried my memory chip. The handyboard downloads Pcode perfectly, but when it tries to synchronize with interactive C, I get an error. While the board is off the 62256-12LP and the 74HC132 chips stay hot. is there a good diagnostic (...) (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
|
|
| | Expansion Board and Smooth PWM
|
|
I really need to know how to get all my files correct to run both the expansion board and the smooth PWM routines at the same time. I downloaded both zip files but am unsure which files to use. Did I miss something on the web page where it says how (...) (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
|
|
| | Re: MOTOR DRIVERS
|
|
(...) Hi Paul, I don't know how the handyboard is protected against overload but one thing is for sure : if you overload the driver chip ... this one will fry up.In worst case you'll fry the board as well. If a driver chip's maximum current is 1 (...) (25 years ago, 25-Oct-99, to lugnet.robotics.handyboard)
|
|
| | Re: MOTOR DRIVERS
|
|
It won't necessarily fry the chip. L293s (and the TI equivalent) have a thermal protection mode. If the chip gets too hot, it will turn itself off. Most of the time, this protects the chip against over-current. However, it is still possible to fry (...) (25 years ago, 25-Oct-99, to lugnet.robotics.handyboard)
|
|
| | Re: MOTOR DRIVERS
|
|
(...) Hi Paul, I think it would take out the chip, but I am currently doing this by installing a oversize heatsink & fan to the controller chip and pulsing the motor instead of constant current. Exceeding the max current capacity but, limiting (...) (25 years ago, 25-Oct-99, to lugnet.robotics.handyboard)
|
|
| | Re: MOTOR DRIVERS
|
|
Answer it'll fry the chip Question? Why would you even want to do that? (...) (25 years ago, 25-Oct-99, to lugnet.robotics.handyboard)
|
|
| | MOTOR DRIVERS
|
|
Question? When using a motor which will exceed the driver chip max current, will that fry the chip or the handy board? Paul (25 years ago, 25-Oct-99, to lugnet.robotics.handyboard)
|