 | | Eltec 442 Pyroelectric Sensor
|
|
Hi, I purchased an Eltec 442-3 Pyroelectric Sensor from acroname. I know pin 1 is V+ 5V but I don't know how I should connect pin 2,3,4 to my handy bord/expansion board. I want to use the sensor for detecting people and/or candles. How do I connect (...) (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | Re: fried memory
|
|
it might not be permanently dead, but if it's not, it's not working. one (or more) of the outputs of these two chips is probably shorted to ground or shorted to +5v. the chips get hot when they try to drive this output to a state other than the one (...) (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | fried memory
|
|
I suspect that I fried my memory chip. The handyboard downloads Pcode perfectly, but when it tries to synchronize with interactive C, I get an error. While the board is off the 62256-12LP and the 74HC132 chips stay hot. is there a good diagnostic (...) (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | Expansion Board and Smooth PWM
|
|
I really need to know how to get all my files correct to run both the expansion board and the smooth PWM routines at the same time. I downloaded both zip files but am unsure which files to use. Did I miss something on the web page where it says how (...) (25 years ago, 26-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | Re: MOTOR DRIVERS
|
|
(...) Hi Paul, I don't know how the handyboard is protected against overload but one thing is for sure : if you overload the driver chip ... this one will fry up.In worst case you'll fry the board as well. If a driver chip's maximum current is 1 (...) (25 years ago, 25-Oct-99, to lugnet.robotics.handyboard)
|
