 | | Re: Motor Controller Question
|
|
bruce, for the HB you need to write data to $7000 to control the motors. see appendix B of the 6.270 manual at (URL) also the HB FAQ (URL) your message you said: (...) (25 years ago, 13-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | Motor Controller Question
|
|
From what I could figure out from the literature on the HB, the motor controller circuit is controlled by Port B on the 6811. With a little tinkerin last nite I was trying to set/reset some of the pins poking values into $1004 (Got this from "An (...) (25 years ago, 13-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Error at address 0x0000
|
|
Hi, That error message is actually to do with a fault in the Borland Delphi code for serial transfer, NOT a fault with the HandyBoard! (I use the same Delphi code in my HandyBoard terminal program as the program HBDL). It appears to manily occur on (...) (25 years ago, 13-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | RE: Stepper Motors
|
|
(URL) the interactive c page .-----Original Message----- .From: T.C. [mailto:dab8rs_85@yahoo.com] .Sent: Monday, October 11, 1999 3:49 PM .To: handyboard@media.mit.edu .Subject: Stepper Motors . . .Can anyone give me a sample program on how to (...) (25 years ago, 12-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | IR sensor for Program download to HandyBoard ??
|
|
Hi , I am new to Handyboard and have these IR questions. Can the IR sensor be used to download programs to the HandyBoard? my idea is to dynamically load programs to the handyboard using IR communication . or Can RF communication be used? Is is (...) (25 years ago, 12-Oct-99, to lugnet.robotics.handyboard)
|
