| | Re: IC motion control
|
|
your motor probably draws too much current to work with the HB. unplug the motor and see if things work. if so, the problem is your motor. see the FAQ more for on how to choose a motor that works with the HB. fred In your message you said: (...) (25 years ago, 2-Oct-99, to lugnet.robotics.handyboard)
|
|
| | tiny gears
|
|
I'm looking for a very small set of gears. For example, I need a worm with a 0.025" diameter bore and another with a 0.040" diameter bore. Both of these could be as long as 3/8". The size of the worm gears doesn't matter too much, although I'd like (...) (25 years ago, 2-Oct-99, to lugnet.robotics.handyboard)
|
|
| | does a common pic programer work with the sx microchips
|
|
does a common pic programer work with the sx microchips ===== (25 years ago, 2-Oct-99, to lugnet.robotics.handyboard)
|
|
| | IC motion control
|
|
I am having problems with programming the handyboard using Interactive C 3.2. When I used the function fd(n) to test for continuous motor rotation, the board would crashed or it would only spin for a fraction of a second. Also, even when I put it in (...) (25 years ago, 2-Oct-99, to lugnet.robotics.handyboard)
|
|
| | Re: IC on Irix
|
|
(...) There's no reason there should be a problem with this. The HB interface uses fully standard serial comms protocols. All you have to do is get the right cable to connect the HB interface to your SGI. The HB interface acts like a modem with a (...) (25 years ago, 2-Oct-99, to lugnet.robotics.handyboard)
|