| | Lo-Tech for Hi-Tech swaps, anyone?
|
|
I plan to use the Handyboard within a Course on Interfacing, Microcontroller and Assembly Language Programming at undergraduate level here, starting next month. It turns out that there is a PCB production facility here in Zimbabwe which is now (...) (25 years ago, 28-Sep-99, to lugnet.robotics.handyboard)
|
|
| | (canceled)
|
|
|
|
| | hbtest.c
|
|
Hi, I'm assembling a handyboard and am at the stage where the digital inputs are tested using the testdigitals() function of hbtest.c. The test partially works, and I get the beeps after pressing the start and stop buttons, but when I jumper the (...) (25 years ago, 28-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Re: Problem with bootstrap mode
|
|
Hi Raj - - Trickle charge the battery for awhile (with the HB turned off), then try it again. Good luck, - Nick - (...) (25 years ago, 27-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Problem with bootstrap mode
|
|
Hi I am having hard time in putting my handyboard in bootstrap mode. I didn't used my board in months , so it run out off power. when i tried to use it display is not working properly. The first line of the display is not working. when i swithed on (...) (25 years ago, 27-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Re: Analog I/O as Digital I/O
|
|
Also, the "digital(int p)" extends to the analog ports too. When used with a port that is analog in hardware, it just uses 127 as a threshold value to return 1 or 0 (note below 127 returns true). See page 22 in the HB manual. However, with this (...) (25 years ago, 27-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Re: Analog I/O as Digital I/O
|
|
(...) Since the analog inputs read voltage levels, you should be able to just plug in any switch or 5-0volt input directly. To read the values, use the analog command, and in theory you should only get two possible values, 255 for +5volts, and 0 for (...) (25 years ago, 27-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Analog I/O as Digital I/O
|
|
Can the analog input lines be used as a digital input lines (if there is no requirement of analog input)? Because, these lines are connected to the port E of 68hc11, then what are modifications required in the code? Asim Kar. City University of Hong (...) (25 years ago, 27-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Serial transmiter
|
|
Does anyone know of a 9600(8,N,1) serial port transmitter? Or have plans for one? I need one for a telepresence robot that I am designing, Also it needs to be as high of power as it can be I am a HAM novice if it makes a difference Andrew Holland (...) (25 years ago, 25-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Re: Using 12V supply with Expansion Board?
|
|
Duhhhh....don't forget to put heat sink on the 293 motor drivers or else you will fry it! Thank You Bart Chrijver for the reminding. Rob (25 years ago, 25-Sep-99, to lugnet.robotics.handyboard)
|