| | Pulse timing
|
|
Hi all, After reading this Tilt Sensor message I had a look at www.analog.com and found they did samples of the chip. I got two samples the other day and so made a quick test pcb. The board seems to work ok looking at it with a scope but now I want (...) (25 years ago, 27-Jul-99, to lugnet.robotics.handyboard)
|
|
| | Re: Interfacing handyboard with Basic Stamp2
|
|
Hi, You can use the SPI interface and have the BS2 as a master. The BS2 then defines the clockspeed, because the slowest speed you can select on the 6811 is probably to high for the BS2. It is very simple to use this interface. See the "pink book" (...) (25 years ago, 27-Jul-99, to lugnet.robotics.handyboard)
|
|
| | Re: Voice Recognition Hardware
|
|
I actually bought one of these units (used) but have been unable to find out anything at all about them beyond the canned software. Any hints as to any sources? Ken McKinnon klmckin@magmacom.com (...) (25 years ago, 27-Jul-99, to lugnet.robotics.handyboard)
|
|
| | Re: HB Serial line speed change
|
|
(...) I haven't looked at the schematics for the handyboard for a while, but if you use an E-series processor, then I think you can go up to 12MHz (3 MHz E-Clock). I'm not sure whether the rest of the Handyboard could take the increased speed, and (...) (25 years ago, 26-Jul-99, to lugnet.robotics.handyboard)
|
|
| | Interfacing handyboard with Basic Stamp2
|
|
Hello to everybody. I would like to ask if is possible to interface the handyboard with the basic stamp2 using not the RS232. Thanks beforehand. (25 years ago, 26-Jul-99, to lugnet.robotics.handyboard)
|