 | | Re: Increasing current output to motors on HandyBoard
|
|
So that's like $28 for the H excluding the protecting circuitry? How much did this setup cost for both motors? ---...--- ericson mar Robotics Consultant mar@cooper.edu (212)353-4356 Department of Mechanical Engineering The Cooper Union for the (...) (25 years ago, 10-Apr-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Increasing current output to motors on HandyBoard
|
|
Howdy, My original suggestion was to use *solid state* relays. They don't have any contacts. I use them plugged right into my Rug Warrior board at the motor output ports (would work the same on my Handy Board, but I have it on a smaller base, and (...) (25 years ago, 10-Apr-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Increasing current output to motors on HandyBoard
|
|
Haven't actually tried it, but I was thinking of the same sort of thing. Use a FET for PWM and a DPDT relay for direction. practically speaking, if you only switched the relay when the FET was off, no power transition, etc.... If your 'bot moves (...) (25 years ago, 10-Apr-99, to lugnet.robotics.handyboard)
|
| |
| | GCC/HC11 small patch
|
|
I contacted the original person who did the HC11 port to gcc (Otto Lind), and he pointed me to a patch for it. If you're using gcc-2.8.1 with the HC11 patches in it, you may want to try this: At line 502 of config/m6811/m6811.c, change from: { (...) (25 years ago, 9-Apr-99, to lugnet.robotics.handyboard)
|
| |
| | Re: GCC 2.8.1 for HC11
|
|
(...) You can have a copy of mine if you like. You can relocate it to any available digital ports with ease. It is set up for a single sensor, but you can easily add as many as you have ports for. (...) For people using the Handy Board in small (...) (25 years ago, 9-Apr-99, to lugnet.robotics.handyboard)
|
