 | | MAX232 help
|
|
Hello, I just began construction on my Interface/charger board and all of the preliminary test voltages check out as expected except for the voltage at pin 3 of J9 when pin 6 is jumpered to pin 10 of the MAX232 chip. Do you have any suggestions? (...) (26 years ago, 30-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Help needed! Additional info Part 2
|
|
Hi everybody! I've still not solved my problem, but I've been experimenting a bit around while waiting for the 'golden tip' from one of you experienced Handy Board users. BTW: I have not yet received any emails via the mailing list, so I'm not yet (...) (26 years ago, 30-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Best way for HB to communicate to a PC?
|
|
Hi all, I'd like to write some routines on a PC to communicate through the RS232 port to a Handyboard. I'd like to use the Handyboard as the sensor and motor controller and use the Dauphin DTR-1 PC that I got for the navigation and logic processor. (...) (26 years ago, 30-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Re: GCC 2.8.1 for HC11
|
|
(...) ftp://ftp.cmf.nrl.na...l/pub/kenh In fact ... you can't use the MiniBoard library without that cross-assembler (not without some serious hacking). --Ken (26 years ago, 30-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Re: GCC 2.8.1 for HC11
|
|
(...) Nope. Where's your version? If it's easier to use libraries with yours, I'll use that instead. I want to write a Handyboard library when I get the toolchain working (but you know that already). (...) Glad to hear it, 'cuz I'm going towards GCC (...) (26 years ago, 30-Mar-99, to lugnet.robotics.handyboard)
|
