 | | RE: IR outputB
|
|
So, it seems like the short answer to this question is no one knows what to attach to correctly and safely (to prevent HB damage) allow IR transmissions from the HB :) I understand the receiving capabilities, as they are documented and have routines (...) (28 years ago, 25-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Another IC error: "Out of memory"
|
|
Hi everyone: I went back and rethought this: (...) I played around it it some more, removed the 'scamper' gait, and got the size of code IC loads down to 12500 bytes, and the error is gone. I'm not sure if this means I have some 3k of variables, or (...) (28 years ago, 25-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Another IC error: "Out of memory"
|
|
Thanks again for all the help with the "yacc" error I experienced before. I'm having new code resourcing problems now: mainly a problem with my 1994 version 2.851 interactive c. It loads my libraries, and I'm getting an error: "Out of memory (tried (...) (28 years ago, 25-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | RE: IR outputB
|
|
(...) It is not the bouncing off of things but the passing through them that makes RF able to operate without line of sight. Line of sight gives greater distances, though, even with RF. The Lynx Tx/RX will definately have a greater range than the (...) (28 years ago, 25-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: How to measure the signal Voltage ?
|
|
not knowing anything about the sensor, but guessing (hoping) that it behaves like an open collector gate, this is what i would do--fool with the sensor on the bench to determine how it works before i let it near the HB. 1. power up the sensor, (...) (28 years ago, 24-Feb-99, to lugnet.robotics.handyboard)
|
