|
|
 | | Parts availability
|
| To all: I am constructing the Handy Board from 'scratch', since many places want upwards of $200 for a built (and tested) board. I have located most of the required parts, but have not located the following: the 1 uH iron core inductor the 5W 47ohm (...) (26 years ago, 24-Feb-99, to lugnet.robotics.handyboard)
| | | | | How to measure the signal Voltage ?
|
| Hi Everybody, I am using the retroreflective sensor to an object . The sensor is came from Masushita NAIS brand name. It has 3 wires . ONe for the +ve supply , one for the -ve supply, one for the output signal line. The sensor is using a NPN type. (...) (26 years ago, 24-Feb-99, to lugnet.robotics.handyboard)
| | | | | Print to LCD
|
| Hi everyone, Does anyone know how to print messages to the LCD in assembly language. Thanks (26 years ago, 24-Feb-99, to lugnet.robotics.handyboard)
| | | | | RE: External Motor Power and the Expansion board.
|
| I noticed this to when I built mine, I just bridged the gap I had cut with solder and now use an H-bridge to control the motors. Clancy (...) (26 years ago, 24-Feb-99, to lugnet.robotics.handyboard)
| | | | | Problem resolved?
|
| To all, Regarding my previous... I am not sure if it was a soldering connection, but after retesting the output voltages it is very close.. Fred says that the voltages should be between, say, +9 and +10, but I'll get a 8.7.. Is this good enough? If (...) (26 years ago, 24-Feb-99, to lugnet.robotics.handyboard)
|
|
